Company:
Detroit Engineered Products (DEP)
Location: Sterling Heights
Closing Date: 22/10/2024
Hours: Full Time
Type: Permanent
Job Requirements / Description
Position Requirements:
Bachelors degree in Electrical Engineering, Computer Engineering (BSCE), Mechatronics, Robotics or related degree program
2+ years of relevant experience on up
Ability to use Engineering Development and Test Tools.
Ability to develop technical solutions to complex problems
Ability to interact with senior external personnel on tech matters
Aware of and directs activities towards completion of major program goals
Ability to travel to supplier and government sites as needed
Knowledge in many, but not all, of the following areas desired
IPC and MIL standards
Digital and Analog circuit design
Gyroscopes, Encoders, and Cameras
Development of component/subsystem requirements
Model-based Motion Control
PWM and PID
Test Equipment (Power Supplies, Oscilloscopes, Function Generators, DACs)
Power, thermal analysis, timing, biasing, voltage and current control, LED control, data packet deciphering, etc.
Schematic development, component selection, circuit simulation, and PCB layout
Engineering design, development, and analysis software
Servo Control experience
MATLAB Simulink Control experience , MATHCAD, Mentor Graphics Schematic Capture, CAMView or CAM350
Microprocessor based products including processors, chipsets, memory and bus interfaces, networking standards (PCI-xpress, DDR2, DDR3, USB, SATA, DVI, etc...)
Microcontrollers including IDEs, configuration, coding, programming and NXP family of microcontrollers
Industry interface standards and form factors (VITA42/46, COM Express, ETX, etc.)
Serial Interconnects, USB, CAN, RS422/485, etc.)
Graphics/video interfaces (SDI, DVI, HDMI, RS-170, etc.)
EMI/EMC design practices and standards.
C, C#, VisualStudio Suite
Bachelors degree in Electrical Engineering, Computer Engineering (BSCE), Mechatronics, Robotics or related degree program
2+ years of relevant experience on up
Ability to use Engineering Development and Test Tools.
Ability to develop technical solutions to complex problems
Ability to interact with senior external personnel on tech matters
Aware of and directs activities towards completion of major program goals
Ability to travel to supplier and government sites as needed
Knowledge in many, but not all, of the following areas desired
IPC and MIL standards
Digital and Analog circuit design
Gyroscopes, Encoders, and Cameras
Development of component/subsystem requirements
Model-based Motion Control
PWM and PID
Test Equipment (Power Supplies, Oscilloscopes, Function Generators, DACs)
Power, thermal analysis, timing, biasing, voltage and current control, LED control, data packet deciphering, etc.
Schematic development, component selection, circuit simulation, and PCB layout
Engineering design, development, and analysis software
Servo Control experience
MATLAB Simulink Control experience , MATHCAD, Mentor Graphics Schematic Capture, CAMView or CAM350
Microprocessor based products including processors, chipsets, memory and bus interfaces, networking standards (PCI-xpress, DDR2, DDR3, USB, SATA, DVI, etc...)
Microcontrollers including IDEs, configuration, coding, programming and NXP family of microcontrollers
Industry interface standards and form factors (VITA42/46, COM Express, ETX, etc.)
Serial Interconnects, USB, CAN, RS422/485, etc.)
Graphics/video interfaces (SDI, DVI, HDMI, RS-170, etc.)
EMI/EMC design practices and standards.
C, C#, VisualStudio Suite
Share this job
Useful Links